Circulator for heating and air-conditioning systems
EVOPLUS circulation electronic pumps can be used in heating, ventilation, and air conditioning systems for residential and commercial buildings, like:
-Large residential buildings -Condominiums and small apartment buildings -Homes
-Private and public hospitals -Schools -Office buildings
-Real estate buildings
All the models are available both in the single and twin version.
Bronze pump execution for the recirculation of sanitary water, available in single version with DN 32, DN 40, DN 50 and DN 65 flanged ports. Supplied as a standard ready for control using 0-10 V or PWM external signal, and for the connection to ModBus management systems (LonBus with appropriate communication module available as optional).
Operating range: from 3 a 75.6 m³/h with head of up to 18 metres.
Pumped liquid temperature range: from -10 °C to +110 °C.
Pumped liquid: clean, free of solids and mineral oils, non-viscous, chemically neutral, with properties similar to water. (glycol max 30%).
Maximum operating pressure: 16 bar (1600 kPa).
Standard flanges: DN 32, DN 40, DN 50, DN 65, PN 6 / PN 10 / PN 16 (4 holes), DN 80 and DN 100, PN 6 (4 holes).
Maximum ambient temperature: + 40 °C.
Minimum suction pressure: the values are shown in the corresponding tables.
Special executions on request: DN 80, DN 100 PN 10 / PN 16 (8 holes).
Accessories (Counter flanges): PN 10 DN 32 - DN 40 - DN 50 - DN 65 PN 6 DN 80 - DN 100.
Electromagnetic compatibility: EVOPLUS circulator comply with EN
61800-3 standard, category C2, as far as electromagnetic compatibility.
Electromagnetic emissions - Residential environment (containment measures might be required in some cases). Conducted emissions - Residential environment (containment measures might be required in some cases).
Monobloc circulation pump consisting of the cast iron hydraulic section, and the wet rotor synchronous motor. Aluminium motor casing. Scroll type pump body featuring high hydraulic efficiency thanks to highly precise design and smooth internal surfaces. In-line suction and delivery ports. The single version is supplied as standard with insulating casing, to avoid heat dispersion and/or the formation of condensation on the pump body. For the twin version, the insulation must be provided by the installer. In any case, pay attention not to obstruct the condensation drainage ducts, to avoid impairing the operation of the circulator.