3D Viewer

EKINEX® EK-MEK-XX

Kit with network analyser and Rogowski coils

Manufacturer Ekinex® by SBS

The kit ekinex® EK-MEK includes a EK-ME1-MDE network analyzer (enhanced version) and three sensors for measurement and recording of Rogowski current. Sensors are available with the following lengths: 300, 450 and 700 mm.

Dimensions

Technical features

Electrical features
• Output level (RMS): 100 mV / 1 kA @50Hz (standard)
• Transducer resistance: from 70 to 900 Ω
• Position error: less than ±1% of reading (with wire diameter = 15 mm)
• Frequency: around 40 Hz at 20 kHz
• Operating voltage: 1000 VRMS CAT III, 600 VRMS CAT IV
• Pollution degree 2
• Test voltage: 7400 VRMS / 1 min
Connection wires
• Type: 2 x 0,15 mm shielded
• Length: 300 cm
Functions (network analyzer)
• Fully bidirectional four quadrants measurements for all energies and powers
• Main electrical parameters measured and displayed for a cost effective consumption analysis
• Version for 1 or 5A CT
• 8 MB for data recording
• Possibility to record MIN / AVG / MAX for instantaneous parameters
• Possibility to record all energy counters
• Modbus RTU / ASCII communication by RS485 port
• Possibility to manage the instrument in remote mode by WintoolNETME1 soft
Network analyzer
• Plastic casing
• Backlighted LC-Display, 43 x 29 mm 3 rows, 4 digits + symbols
• Keyboard: 3 front buttons + 1 protected button
• Screw terminal blocks connection
• Installation on 35 mm DIN rail (according to EN 60715)
• 4 modular units (1 MU = 18 mm)
• Protection degree IP20 (installed device)
• Weight 260 g
Transducer (Rogowski coils)
• Coil length: 30, 45 or 70 cm
• Wire diameter: 8,3 ± 0,2 mm
• Closing: bayonet
• Weight: from 150 to 500 g
• Material: thermoplastic UL94-V0

Ekinex® by SBS Catalogues

Kit with network analyser and Rogowski coils EKINEX® EK-MEK-XX - Ekinex® by SBS

Kit with network analyser and Rogowski coils EKINEX® EK-MEK-XX - Ekinex® by SBS
Loading Extra News
Loading event fair
Qr-code
Loading product info request form

Tags