Base coat and impregnating compound for paint and varnish

Add to wishlist

More on Brand


Portogruaro, Italy
Contact the company
Name of product/article



Base coat and impregnating compound for paint and varnish

Sandable primer for wooden substrates, easy to apply, ideal for professional use as it has high filling powers, good adhesion to various types of wood and it is fast drying, allowing an overall reduction in painting time. It forms a film-like undercoat which guarantees the adhesion of the finishing coats, evenness of finish and uniform covering of the film. Formulated with acrylic resins in aqueous dispersion, it is ideal for painting systems designed for both interior and exterior structures. It guarantees good penetration of the wood pores with minimum swelling of the wood fibre, good sandability and manual or mechanical brushing and a particularly elastic film that withstands the dimensional variations typical of wood exposed to exterior environments. Highly run-resistant, it can be applied thickly in a single coat.  Being odourless, it is particularly suitable for poorly ventilated areas. COLOURS:White. USE:As an undercoat on raw surfaces of various types of wood, in the transparent painting cycle with water-dilutable acrylic finish on structures such as fixtures in general. Sandpapering must be carried out without removing a large quantity of the dry film so as to maintain enough film to guarantee an even finish. If the product has been stored at low temperatures, allow it to reach a temperature of at least +15 °C before applying. During application and drying time, the temperature should be higher than +15°C and the humidity of the air lower than 65%; it is important for the environment to be well-ventilated in order to facilitate water evaporation. Remember that applying thicker coats of paint than those indicated or different environmental conditions can cause a lengthening of the indicated drying times, as the evaporation of the water slows down. Drying can be done at ambient temperature or with a hot air tunnel (35°-50°C), in which case sandpapering may be carried out after 3-5 hours. It is not suitable for woods containing tannin (oak, chestnut, hemlock) or porous, oily or resinous wood (iroko, Siberian larch and marine plywood). During application and drying time, temperatures must be above +15°C and  ambient humidity less than 65%. Brushing, as opposed to sandpapering, guarantees a better aesthetic finish. TOOLS:Brush, Roller, Aircoat spray-gun. THINNING:Ready to use. COVERAGE:8-10 sq.m/l per coat. DRYING:Fully dry 6h. APPLICATION TEMPERATURE:+5°C +30°C. STORAGE:+5°C e +30°C.

Further info from manufacturer on OPAKITE W

Lasurcap Collection by CAP ARREGHINI
You might also like...
Recently Viewed