Share

Ekinex EKINEX® EK-HH1-TP

Mixing actuator

Get directly in touch with Ekinex

Add to wishlist

More on Brand

Ekinex

Vaprio d'Agogna, Italy
Contact the company
Overview
Name of product/article

EKINEX® EK-HH1-TP

Type

Mixing actuator

The ekinex® EK-HH1-TP mixing actuator allows the control of 3 floating points or 0-10 V servo-motor for mixing valves. The flow temperature of the conveying fluid can be set at a fixed point, with external climatic compensation and with external climatic compensation plus internal conditions recalibration. The regulation modes are selectable separately for heating and cooling. The device is particularly suitable for underfloor or ceiling heating and cooling radiant panels applications in combination with ekinex® room thermostats with integrated temperature and humidity sensor.

A 0-10 V output allows the remote setting of a heat pump temperature setpoint value. The startup function enables a radiant floors drying concrete phase according to EN 1264
standard. The membrane keyboard allows the manual command and includes LED’s for status indication; the LC-display allows displaying / setting of the main working parameters. The device integrates a KNX bus communication module and is realized for mounting on a standard 35 mm DIN-rail. The device is supplied by the KNX bus and requires an additional 230 Vac power supply to operate.

Further info from manufacturer on EKINEX® EK-HH1-TP
Further details
Power supply
• Voltage (loads) 230 Vac 50/60 Hz
• Voltage (electronics) 30 Vdc by KNX bus
Inputs
• 3 freely configurable for passive temperature sensors (10 kΩ NTC at 25°C) or as potential-free binary inputs
• 2 potential-free binary inputs
Outputs
• 2 TRIAC to command a 3 floating points mixing valve actuator
• 1 with 0-10 V signal to remotely control a temperature setpoint value (for heat pumps)
• 3 relays SPST (single pole, single throw) to control ON / OFF zone valve drives
Main characteristics
• Plastic casing
• Frontal programming pushbutton and LED
• Membrane keyboard with LED’s for status indication
• Pushbutton for switching operating mode (normal / programming)
• Connection to bus line with KNX terminal block
• Connection of inputs, outputs and 230 Vac power supply with screw terminals
• Classification climatic 3K5 and mechanical 3M2 (according to EN 50491-2)
• Overvoltage class III (according to EN 60664-1)
• Pollution degree 2 (according to IEC 60664-1)
• 35 mm rail mounting (according to EN 60715)
• 8 modular units (1 MU = 18 mm)
• IP20 protection degree (installed device)

You might also like...
Recently Viewed