Automation and control for opening
The 950 BM automated system for swing doors is an enbloc unit consisting of an electromechanical device that allows door opening to be controlled by means of a driving arm. The door is re-closed by a spring system. The operator can be installed either on the lintel or on the door structure itself. The ABS-plastic protective casing houses the electronic control unit used to program and control the operation of the system. In the event of a power failure the door can be pushed (or pulled) open manually. The 950 automated systems command door opening and closing in absolute operating silence, both in the spring version and in the motorised closing version. The automated systems Faac 950 BM (with spring closing system) and the 950 BSM (with motorised closing system without spring) can be installed both on the lintel and directly on the door’s structure. The housing covering the automated system can be supplied in anodized extruded aluminium or in shaped ABS in an innovative design making it possible to fit a detection sensor (passive infrared) inside it. The automated system has two control boards: 950 MPS (control board) and 950 I/O (input/output). A microprocessor controls all the door’s activities in real time, and an encoder detects its angular position at all times. Moreover, you select the operating logic (automatic, manual, night, open) by means of an integrated selector. Built in conformity with the new European safety regulations, speed and force are programmed according to the size of the door. If an obstacle is detected, the door reopens immediately, and as it closes it verifies, at slow speed, the release of the obstacle. Thanks to the accurate selection of the mechanical and electronic components, our 950 BM automated system is able to move leaves weighing over 300 kg, on continuous duty, while always maintaining absolute operational safety.